9/01958 Holdback unit, with striker and mounting gasket
Ordering Code
9/01958 | Rotary holdback and striker, panel fixing |
9/01954 | Rotary holdback and striker, for glass fixing |
Specification
All dimensions shown are rounded to the nearest millimetre. Please request a drawing for the exact product specific and tolerances.
A | Total depth | 52 mm |
B | Body diameter | 44 mm |
C | Striker body projection | 18 mm |
D | Striker piercing (dia) | 16 mm |
E | Fixing holes (dia) | 54 mm |
H | Hole sizes (dia) | 6 mm |
Note: Holdback & striker are designed tosuit 3mm-thick panels.
- As the unit is slammed, the striker pin causes two sprung pins to separate and then close again behind the shaped 'nose'. Action of the operating levers will release the pins, and a sprung central plunger ensures the striker pin is ejected.
- Inside or outside release levers are rotated in either direction through approximately 15 degrees to disengage striker pin.
- Unit is mounted from outside through a circular aperture and is fixed through three equi-distant mounting holes. A gasket is supplied. Striker pin is secured by single hexagon bolt at rear, also with gasket.
- Unit is self-coloured with textured black finish. Striker pin, 'jaws' and entry sleeve are bright nickel-plated.
- 'O'-ring fixing through varying glass thickness. With/without exterior release lever. Striker pin/buffer length variable.