9/01830 Right-hand latch with fitted cover and integral inside handle
Ordering Code
9/01830 | Latch assembly, RH |
9/01831 | Latch assembly, LH |
9/01832 | Striker pin |
Note: Above assemblies include steel coverplate, moulded trim cover and inside releasehandle
Specification
All dimensions shown are rounded to the nearest millimetre. Please request a drawing for the exact product specific and tolerances.
A | Height | 80 mm |
B | Width | 47 mm |
C | Depth | 17 mm |
D | Location to hole | 26 mm |
E | Length, handle | 80 mm |
F | Location to face | 9 mm |
G | Location to latch centre | 19 mm |
H | Hole sizes | 6 mm |
J | Hole centres | 31.5 mm |
K | Hole size (Threaded) | M6 |
L | Pin total length | 41 mm |
M | Threaded | 12 mm x 1 mm fine pitch |
N | Hexagon across flats | 16 mm |
- Two-stage rotary action, integral inside release, with fixing holes concealed by trim cover. Steel cover plate reinforces latch to increase strength rating.
- ‘Handing’ shown for front-hinged doors. Reverse handing for front-opening.
- Latch slams against pin-striker, is released by exterior ‘trigger’ or by lifting inside handle. There is no inside locking function.
- Attach to door edge by 2 x M6 high-tensile bolts through steel cover plate (which must be used). Trim cover is retained by M6 screw into threaded hole on side-face.
- Black zinc-plated with moulded trim cover and inside release, bright zinc plated striker.
- When rig-tested these latches can achieve values in excess of 8.9KN (2000lb) Transverse load in fully-latched condition. The design is intended for off-road vehicles, and constructors are responsible for evaluating performance in their own particular application and for ensuring that appropriate legislation is satisfied.