9/02028 (in stainless steel)
Double-sided “FT” keys as standard
Ordering Code
Stainless steel models with plain rim | |
9/02028 | Deep-dish paddle, locking |
9/02028/01 | As above, FT111 |
9/02029 | Deep-dish paddle, non-locking |
Stud-fixed models - Blind-mounting models have four studs (M6x10mm) welded on inside rim. Consult engineering drawing for position of studs. see page C19
Specification
All dimensions shown are rounded to the nearest millimetre. Please request a drawing for the exact product specific and tolerances.
A | Case length | 170 mm |
B | Case width | 110 mm |
C | Hole centres | 100 mm |
D | Hole centres | 99 mm |
E | Bolt projection (max) | 28 mm |
F | Bolt depth | 30 mm |
G | Bolt width | 19 mm |
H | Hole sizes (dia) | 7 mm |
J | Maximum depth | 44 mm |
K | Recess length | 142 mm |
L | Recess width | 82 mm |
- Deep dish (30 mm) with internal finger-shield and beaded edge on flap for easy operation. Stainless locking bolt slides on carrier, giving protection against flap being forced. Low-profile lock with double-sided key cylinder as standard.
- Slam action against door frame or striker, released by lifting flap.
- Locking with key blocks movement of flap, but slam bolt can still be slammed and opened from inside.
- Pierced rim, internal welded studs, or plain rim with mild steel models (for weld-on fixing). Gasket supplied.
- ‘FT’ keys as standard, with shuttered keyway. Optionally, ‘FS’, ‘92’, ‘DLP’ or ‘Ronis’ key types. Non-locking models.
- Polished stainless steel, clear zinc-plated. Optionally, black powder-coated finish.
- With stainless models, all components made in Grade 304. With mild steel models, case and flap in CR4 with mild steel slam bolt.
- Alternative slam bolts (length, profile). Inside release knob.
- Tested to destruction, paddle flap withstood a direct load of 42Nm (2.45KN). Equivalent to a ‘pull’ of 245Kg (540lbs). Endurance (cycle) testing: The latch was slammed/opened for over 50,000 cycles with no discernable wear.